The Reinforcement Layer In The Hydraulic & Pneumatic Tube Can Be Both A Programmed And A Remnant Wound.

Simply speaking, the main factors in choosing the Hydraulic & Pneumatic Tube form are system pressure, pressure fluctuations, oil flow rate, temperature, oil and environmental conditions. The high pressure hoses for hydraulic systems in Hydraulic & Pneumatic Tube are made of synthetic rubber and are reinforced according to the intended load. The Hydraulic & Pneumatic Tube is in contact with the oil. The inner tube is made of oil-resistant synthetic rubber. The inner tube has a number of reinforcing layers on the outside. The reinforcing material is natural or synthetic fiber yarn, wire or a combination thereof. The reinforcement layer in the Hydraulic & Pneumatic Tube can be both a programmed and a remnant wound. The outermost layer is a layer of oil-resistant skin, with a layer of adhesive between the layers.

The hydraulic hose in the Hydraulic & Pneumatic Tube can also pass water, dilute sulfuric acid solution, steam not exceeding 100 degrees Celsius, mud, etc. In the Hydraulic & Pneumatic Tube, the rubber-resistant hose can be used up to 130 degrees. Of course, the hose type of the sandblasting series is more suitable for use on the mud. There are many more, as long as the role of the Hydraulic & Pneumatic Tube is the same, the hose under the same pressure can be used in emergency use.